Gargoyle 1.9.2 on TP Link Archer C7 V2 VLAN support
Posted: Sat Aug 19, 2017 10:55 am
Hi !
I am new to Gargoyle but I heard many good things about it. Just installed it on a Archer C7 V2 and I like the clean, polished interface. My only problem is that I do not see VLAN support anywhere in the GUI. I could create them in command line but I saw a post regarding Gargoyle 1.6.2 where the VLAN config was being overwritten by the Connection section of the GUI. Is the situation still the same in 1.9.2 ? Is there a plugin available or perhaps a roadmap for support ? Otherwise I´ll have to go to Lede/OpenWRT/LuCI.
I am new to Gargoyle but I heard many good things about it. Just installed it on a Archer C7 V2 and I like the clean, polished interface. My only problem is that I do not see VLAN support anywhere in the GUI. I could create them in command line but I saw a post regarding Gargoyle 1.6.2 where the VLAN config was being overwritten by the Connection section of the GUI. Is the situation still the same in 1.9.2 ? Is there a plugin available or perhaps a roadmap for support ? Otherwise I´ll have to go to Lede/OpenWRT/LuCI.