changing Transmit Power on Linksys wrt1900acs
Posted: Mon Jul 17, 2017 8:02 am
Installed 1.9.2 on a Linksys wrt1900acs about a week ago.
V smooth, and no problems.
One small thing doesn't seem to work:
I want to reduce the wireless 5ghz (or 2.4ghz) power
(being considerate of my neighbours and my brain).
But no matter what I set the Transmit Power to (2,..,20,...30)
the actual power output level stays the same.
Changing the channel works, just not Transmit Power.
Is this a gui problem
(in which case is there a cli command I can use)
or is it a limitation of the available wireless drivers?
fwiw, changing the Transmit Power on a Netgear wndr3800 running 1.9.1 works fine.
V smooth, and no problems.
One small thing doesn't seem to work:
I want to reduce the wireless 5ghz (or 2.4ghz) power
(being considerate of my neighbours and my brain).
But no matter what I set the Transmit Power to (2,..,20,...30)
the actual power output level stays the same.
Changing the channel works, just not Transmit Power.
Is this a gui problem
(in which case is there a cli command I can use)
or is it a limitation of the available wireless drivers?
fwiw, changing the Transmit Power on a Netgear wndr3800 running 1.9.1 works fine.