Page 1 of 1
Buffalo WHR-G125 Broadcom
Posted: Fri Feb 11, 2011 3:16 am
by demetris
Hi,
WHR-G125 flashed with 1.3.10
gargoyle_1.3.10-brcm47xx-squashfs.trx
Only power led is on.
Other leds off like:
DIAG
ROUTER
LAN
WIRELESS
SECURITY
Re: Buffalo WHR-G125 Broadcom
Posted: Fri Feb 11, 2011 5:29 am
by DoesItMatter
Chipset Broadcom5354
* DD-WRT Wiki: Buffalo
RAM 16 MB
FLASH 4 MB
The WHR-G125 has a 5354 Broadcom chipset
It may not be officially supported since 1.3.10
Can you do the factory revert? The recovery via TFTP?
http://www.dd-wrt.com/wiki/index.php/Re ... _Bad_Flash
See if you can recover via TFTP
IF so, then you can maybe try and flash 1.3.9 - not 1.3.10
gargoyle_1.3.9-brcm-2.4-squashfs.trx
Try that 1.3.9 version and see if the WHR-G125 works
If so, then the changes in 1.3.10 don't support the
WHR-G125 for now, might have to wait for a newer release.
Re: Buffalo WHR-G125 Broadcom
Posted: Fri Feb 11, 2011 6:53 am
by demetris
Thanks for the reply.
Router works just fine no problems
its just the leds not up
After some troubleshoot this leds are impossible to light:
DIAG
LAN
SECURITY
Re: Buffalo WHR-G125 Broadcom
Posted: Fri Feb 11, 2011 11:27 am
by DoesItMatter
http://www.gargoyle-router.com/phpbb/vi ... ?f=7&t=980
See that thread.
Don't think Eric has a WHR-G125 to test with.
If you can figure out what commands will trigger the LED's,
post the info and Eric or some other Dev could get it added to the
GIT for a future release.