Gargoyle Forum

Hello sorry if I am being stupid but I can only find a 35K .torrent file to download and the other file is over 400 megs.
I cant think that either of them are the firmware files.
How do we get this version of firmare?

Regards
Stewart

Use the small torrent file with a torrent client to link to the full torrent (approx 400mb) and pull your individual file from there.

It is the fairest way to share the data with many users.

is there any update after 14th june

sajjadhalai wrote:is there any update after 14th june

There is only one small commit, not sure its worth a new build?

Only relevant to people looking to customise the menu

i used this version with TP lInk wa801ND but it was not working better with that...
some time it was not assigning IP even DHCP is ON.
Some time it removes my static IP list. and Quotas.?
I thought this version is very unstable, so i was waiting for another update.

It only has 4mb of flash. It will be highly unstable on any version after 1.8.1.

Lantis wrote:It only has 4mb of flash. It will be highly unstable on any version after 1.8.1.

I already doubted on it so.
yes it is true. after 1.8 troubles all 4mb routers.

Updated a WD My Net N750, did -not- preserve settings. So far have noticed:

• - Adding themes from plugins (just the version 1.9.2-1 entries) does not cause the Themes item to show up under system, so I can't enable them
  - The Connection Basic config for the 5Ghz allows selection of frequencies that aren't supported? I tried channel 60 and the system logs reports:

  Code: Select all

  Sat Jul 29 20:14:26 2017 daemon.notice netifd: radio1 (5850): wlan1: IEEE 802.11 Configured channel (60) not found from the channel list of current mode (2) IEEE 802.11a
  Sat Jul 29 20:14:26 2017 daemon.warn hostapd: wlan1: IEEE 802.11 Configured channel (60) not found from the channel list of current mode (2) IEEE 802.11a
  Sat Jul 29 20:14:26 2017 daemon.notice netifd: radio1 (5850): wlan1: IEEE 802.11 Hardware does not support configured channel
  Sat Jul 29 20:14:26 2017 daemon.warn hostapd: wlan1: IEEE 802.11 Hardware does not support configured channel
  Sat Jul 29 20:14:26 2017 daemon.notice netifd: radio1 (5850): Could not select hw_mode and channel. (-3)

  I get this same message for selections from 52 thru 140.

Trying on a Linksys WRT1900ACS and noticed that the 5Ghz spectrum analyzer doesn't produce a chart. I know 5Ghz is on and working as I'm connected to it . I don't see anything in the log to help diagnose, is there a way to run it via command line to see why its not working? Thanks!