Page 1 of 1
Where should I enter "service name"?
Posted: Thu Apr 13, 2017 10:57 pm
by Prince.CH
Hello Everyone,
Where should I enter internet service provider service name?
Gargoyle: V1.9.2
Router: TP-Link WR841N
Regards
Re: Where should I enter "service name"?
Posted: Thu Apr 13, 2017 11:20 pm
by Lantis
There is no where to put it. Is this required to make your service work?
Can you provide more details on the type of service and its requirements.
Re: Where should I enter "service name"?
Posted: Fri Apr 14, 2017 4:43 am
by ispyisail
VPN service provider?
Re: Where should I enter "service name"?
Posted: Wed Jul 19, 2017 4:44 am
by AngelNik
Hello,
I want to use Gargoyle-ispy 1.9.2 for my Archer C7 v2 router, but my ISP has a mandatory requirement to enter Service name in the WAN settings. Can you add this field in the Gargoyle interface?
I have looked at the OpenWRT and LEDE forums and I saw that this setting is standard in their interface as well as in the original router firmware, but I want to use Gargoyle! Thanks in advance.
Re: Where should I enter "service name"?
Posted: Wed Jul 19, 2017 5:48 am
by Lantis
For now, you can set this manually at the command line.
https://wiki.openwrt.org/doc/uci/networ ... r_ethernet
Re: Where should I enter "service name"?
Posted: Thu Jul 20, 2017 8:18 pm
by AngelNik
Hello again,
Thanks for the guideline, but I'm newbie to this matter and I could not compile the correct command line. If possible, please give me a script. Thanks in advance.