Gargoyle Forum

Posted: **Thu Feb 16, 2017 6:02 pm**

Hi, I currently am on Wireless Bridge & Repeater mode.
When you're setting up "Connection", as i understand you're shown input fields for encryption when 'SSID to Join' has encryption.

But is there a way to add encryption for 'SSID to Broadcast'?

Posted: **Thu Feb 16, 2017 6:33 pm**

It matches the encryption of the SSID to join.
You are repeating the signal, so all values should be the same.
If you want them different, repeater isn't the config you want.

Posted: **Thu Feb 16, 2017 6:48 pm**

Well, I have gargoyle configured to wirelessly bridge another network. What would be the config I need to create an AP to join to?

Posted: **Fri Feb 17, 2017 5:45 am**

DHCP Wireless will work but everyone will end up on a different subnet

Gargoyle Forum

Is there a way to add encryption to 'SSID to Broadcast'?

Is there a way to add encryption to 'SSID to Broadcast'?

Re: Is there a way to add encryption to 'SSID to Broadcast'?

Re: Is there a way to add encryption to 'SSID to Broadcast'?

Re: Is there a way to add encryption to 'SSID to Broadcast'?