Can't get wireless connection with TL-WR1043ND v2
Posted: Wed Feb 08, 2017 5:45 am
Hello,
I have successfully installed gargoyle v 1.8.1 on this router - using a cable connection from my laptop (which is running Arch Linux). But I can't connect to it wirelessly, and I can't access my modem through it. In fact I have two modems: a 4G wireless broadband Huawei R216h, and 3G broadband wireless USB dongle (not sure of the exact make).
I can plug the USB modem into the router, but that's it - I can't access the internet. I also don't know how to pass network traffic from the wireless broadband modem through my TP-Link router so that all network traffic can be managed by gargoyle.
I'm sure these are both standard configurations, but my hours of fiddling so far (and trying to follow instructions here) have not led to a working solution.
So I'd be happy of some advice! Or pointers to precise instructions.
Thank you very much,
-A.
I have successfully installed gargoyle v 1.8.1 on this router - using a cable connection from my laptop (which is running Arch Linux). But I can't connect to it wirelessly, and I can't access my modem through it. In fact I have two modems: a 4G wireless broadband Huawei R216h, and 3G broadband wireless USB dongle (not sure of the exact make).
I can plug the USB modem into the router, but that's it - I can't access the internet. I also don't know how to pass network traffic from the wireless broadband modem through my TP-Link router so that all network traffic can be managed by gargoyle.
I'm sure these are both standard configurations, but my hours of fiddling so far (and trying to follow instructions here) have not led to a working solution.
So I'd be happy of some advice! Or pointers to precise instructions.
Thank you very much,
-A.