Page 8 of 17
Re: Router Firmware Requests
Posted: Wed Feb 10, 2016 4:50 am
by Lantis
EJM3 wrote:===================================================================
I have a couple of GL.iNet 6416A routers that I use as repeaters for my home net, I already have 1.7.1 installed on them. I'd be willing to slap a copy of 1.9.x onto one & give it a test drive, I'd even be sure to run most traffic through the new install to give it a workout; plus report any bugs back to you...
Thanks in advance
Router Model: GLI GL.iNet 6416A
Link to Openwrt wiki:
https://wiki.openwrt.org/toh/gl-inet/gl-inet_64xx
Is it supported in Openwrt? Yes
Does it have >= 4MB of flash? Yes
Does it have >= 8MB of flash? Yes
Does it have USB support? Yes
Notes from Lantis:
Accepted
EJM3 has reported this firmware as stable.
You can find it
here
Re: Router Firmware Requests
Posted: Mon Feb 29, 2016 10:02 pm
by L0RDZ1C4
Router Model: D-Link Dir-850L ac1200
Link to Openwrt wiki: ------------
Is it supported in Openwrt? I don't know
Does it have > 4MB of flash? Yes
Does it have > 8MB of flash? Yes
Does it have USB support? Yes
I need a help with my router, i wanna put a gargoyle firmware, but i don't know what is compatible. Can you help me?
Thanks
Notes from Lantis:
Rejected - No Openwrt Support
Re: Router Firmware Requests
Posted: Tue Mar 01, 2016 2:13 am
by Lantis
It isn't supported in Openwrt as far as I can tell.
Your first port of call would be to those guys.
If you go to the wikidevi site you can see that there has been some success with getting openwrt to run on similar chipsets so it may be possible in the future at some stage.
Until then however there is nothing I can do sorry.
Re: Router Firmware Requests
Posted: Tue Mar 01, 2016 8:30 am
by Adri
Router Model: Linksys/Cisco WRT320N
Link to Openwrt wiki:
https://wiki.openwrt.org/toh/linksys/wrt320n
Is it supported in Openwrt Chaos_Calmer Branch? Yes
Does it have >= 8MB of flash? Yes
Does it have USB support? No
Router is broadcom BCM4717A1 with 8MB flash.
Almost identical to E2000, except for flash partition layout and bootloader.
Notes from Lantis:
Accepted
Re: Router Firmware Requests
Posted: Sat Mar 12, 2016 11:55 am
by tushal2
Router Name: TP-Link
Model: 841N
Version: V11
Link to Openwrt wiki:
https://wiki.openwrt.org/toh/tp-link/tl-wr841nd
Is it supported in Openwrt? Yes.
4MB Flash
32MB RAM
No USB Support
I want to install gargoyle firmware because of the bandwidth allocated option.
Notes from Lantis:
Rejected - Trunk support only
Re: Router Firmware Requests
Posted: Sat Mar 12, 2016 4:25 pm
by Lantis
The 841n v11 is only supported in the latest trunk builds. If support is back ported to chaos calmer or gargoyle is moves forward you can request again and I'll reevaluate
Cheers .
Re: Router Firmware Requests
Posted: Thu Mar 24, 2016 10:38 am
by neatomos
Kind of a longshot but here goes...
Router Model: Ubiquiti EdgeRouter Lite
Link to Openwrt wiki:
https://wiki.openwrt.org/toh/ubiquiti/edgerouter.lite
Is it supported in Openwrt Chaos_Calmer Branch? Yes
Does it have >= 8MB of flash? Yes
Does it have USB support? Yes
https://forum.openwrt.org/viewtopic.php?id=49908
Re: Router Firmware Requests
Posted: Mon Mar 28, 2016 2:22 pm
by meazz1
I would appreciate if you look into making this firmware available for
Router Model: TP Link TL WR1043 v3.0
Link to Openwrt wiki:
https://wiki.openwrt.org/toh/hwdata/tp- ... r1043nd_v3
Is it supported in Openwrt? Yes
Does it have >= 4MB of flash? Yes
Does it have >= 8MB of flash? Yes
Does it have USB support? Yes
Notes from Lantis:
Accepted
Re: Router Firmware Requests
Posted: Thu Mar 31, 2016 8:10 pm
by rt_rex
Hi guys, is it possible to support this router too?
Thank you.
Router Model: Meraki MR12
Link to Openwrt wiki:
https://wiki.openwrt.org/toh/meraki/mr12
Is it supported in Openwrt? Yes , since r45726 (CC trunk)
Does it have >= 4MB of flash? Yes 16MB
Does it have >= 8MB of flash? Yes 16MB
Does it have USB support? No
Notes from Lantis:
Accepted
Re: Router Firmware Requests
Posted: Wed Apr 06, 2016 9:55 pm
by NineIguanas
TP Link TL WR1043 v3.0
+1 for above request! Would be much appreciated. This chassis is a great work horse with a good radio section - I install a few every week!
Apparently it's the same hardware as v2, just needs the "h/w identifier" code changed.
Router Model: TP Link TL WR1043 v3.0
Link to Openwrt wiki:
https://wiki.openwrt.org/toh/hwdata/tp- ... r1043nd_v3
Is it supported in Openwrt? Yes
Does it have >= 4MB of flash? Yes
Does it have >= 8MB of flash? Yes
Does it have USB support? Yes
Notes from Lantis:
Accepted