Page 6 of 6
Re: Converting from previous pre-installed gargoyle
Posted: Sat Apr 27, 2019 6:41 pm
by James.bailey
Okay. Done and changed applied.
Re: Converting from previous pre-installed gargoyle
Posted: Sat Apr 27, 2019 6:51 pm
by RomanHK
Try the internet.
If it still does not work, now set up the WAN interface correctly (contact your Internet service provider for the IP settings, MAC address, and other information).
Tip1: Information can be in the contract.
Tip2: The PC works directly without a router, then it will be enough to clone the PC's MAC address.
Re: Converting from previous pre-installed gargoyle
Posted: Sat Apr 27, 2019 6:59 pm
by RomanHK
Set the PC back to PC network setup again to be set to "assign IP from DHCP".
You should get the IP from Gargoyle already.
Re: Converting from previous pre-installed gargoyle
Posted: Sat Apr 27, 2019 7:37 pm
by James.bailey
Okay. I am back with the internet but still not sure how to get into the router from a browser. Tomorrow I will repeat what we did today to get back into gargoyle via Ethernet so I can set limits on bandwidth. That’s all for me tonight. Thanks to all. You were amazing.
Re: Converting from previous pre-installed gargoyle
Posted: Sun Apr 28, 2019 3:18 am
by RomanHK
Make sure you have Gargoyle in "Gateway" mode:
