Gargoyle Forum

Lantis wrote: ↑

Sat Apr 06, 2024 6:36 am

Fantastic.
Did you change any of the default settings? You must have set your SSID at a minimum I think?

I did set the same SSID to 2.4G and 5G. Besides, fast roaming is enabled. Nothing's more.

ispyisail wrote: ↑

Sat Apr 06, 2024 1:19 pm

https://openwrt.org/docs/guide-user/network/wifi/usteer

I also notice there is a band_steering_threshold does not take effect unless load_balancing_threshold is also set to a value greater than 0. in the usteer page.

VLAN required by ISP

Happy to see this build being released

can i just check please - my isp requires that I add a vlan ID to my connection details, is that supported in this build?


Many thanks

whataboutnow wrote: ↑

Mon May 13, 2024 4:46 am

VLAN required by ISP

Happy to see this build being released

can i just check please - my isp requires that I add a vlan ID to my connection details, is that supported in this build?


Many thanks

What device do you have?
I finished writing basic WAN side VLAN support last night and need a Guinea pig

hiya sorry for the delay,
I have a wrt3200acm

Happy to do a couple of hours guinea pig over the weekend.

whataboutnow wrote: ↑

Fri May 17, 2024 7:42 am

hiya sorry for the delay,
I have a wrt3200acm

Happy to do a couple of hours guinea pig over the weekend.

I'm compiling a new version for you now. I'll post it in a few hours

EDIT: Available here https://lantisproject.com/gargoyle_cust ... lds/mvebu/

Redmi AX6000 is not supported by Gargoyle 1.15, but it is supported by OpenWrt 23.05.

So I've made the following steps:
- I've cloned gargoyle from github
- I switched to base_on_openwrt_2305 branch
- I've addedd to targets/mediatek/profiles/filogic/config: - I've addedd to targets/mediatek/profiles/filogic/profile_images: Then I've run compilation with: And as a result I have:
gargoyle_1.15.x-mediatek-filogic-xiaomi_redmi-router-ax6000-stock-squashfs-sysupgrade.bin

What is a chance that my AX6000 will run proprely after sysupgrade to this image? It currently has OpenWrt SNAPSHOT installed.

High chance. Sysupgrade without preserving settings.
If it works I’d be happy to add the device (as you have)

oliver44 wrote: ↑

Thu Mar 14, 2024 3:45 am

I would like to install some plugins that I also used on wrt1900acs v2 but I don't know what the command is for GL-MT6000, for wrt1900acs v2 I use

Can you compare performance of your MT6000 with wrt1900acs please? Thanks.

Hi Lantis,
Is there a date to release 1.15 final? Thanks.