Gargoyle Forum

Posted: **Mon Aug 14, 2017 12:44 am**

Lantis wrote:No worries. Thought that would be the answer.
That sets up the correct regulatory settings and lets the DFS module fire.

Might need to start a new thread, or maybe I'm not searching correctly...

After setting this up, things look great and with the suggested settings I get on channel 64 with no problem with my WD My Net N750. However.... after a few days I get a log message of:

Code: Select all

Aug 10 16:34:53 xxxxxx xxxx: hostapd: wlan1: IEEE 802.11 driver had channel switch: freq=5745, ht=1, offset=1, width=2 (40 MHz), cf1=5755, cf2=0

Out of the blue it just changes channels, which is problematic since some of my equipment doesn't like the higher channels. Any idea what causes this?

Posted: **Mon Aug 14, 2017 6:00 am**

Radar (or other) signals which, by law, require the AP to announce an immediate channel switch and vacate the frequency.
It is just doing what is intended.

Gargoyle Forum

gargoyle-ispy 2017-June-14 21:40.torrent

Re: gargoyle-ispy 2017-June-14 21:40.torrent

Re: gargoyle-ispy 2017-June-14 21:40.torrent