Page 3 of 3

Re: How to create separate network / vlan

Posted: Mon Jan 25, 2016 6:19 pm
by shm0
I just asked in the openwrt wrt1900 thread.
Maybe somebody has an idea there.

But i noticed on gargoyle firmware my wan led isnt working? on openwrt it works fine. Can you please have a look?
Thank you :D

Re: How to create separate network / vlan

Posted: Mon Jan 25, 2016 6:57 pm
by Lantis
Works ok for me. Is your power led flashing still?

Re: How to create separate network / vlan

Posted: Thu Jan 28, 2016 2:17 am
by shm0
On openwrt 15.0.5 release build the wan led works fine.
However on latest trunk the led is not working.
The setup for the led in /etc/config/system is the same on both builds and on gargoyle.
So i think it is an openwrt bug.

My power led is only blinking during boot i think. After booting it is steady.