Re: Dynamic DNS Improvements
Posted: Sun Sep 06, 2009 9:27 am
For your public (dynamic) IP to appear at the WAN interface of a router you need to setup the router connection for PPPoE. This involves configuring the upstream modem/router for bridge mode.
I find that it is easier to follow what is going on if you do this setup in two steps:
1. Configure your modem/router for bridge mode operation. Leaving the downstream router (e.g. Gargoyle or dd-wrt etc.) disconnected, connect the modem/router directly to your PC and ensure that you can satisfactorily achieve a connection using the PC's PPPoE client.
2. Next, set up the downstream router to make a PPPoE connection and connect it the modem/router.
I find that it is easier to follow what is going on if you do this setup in two steps:
1. Configure your modem/router for bridge mode operation. Leaving the downstream router (e.g. Gargoyle or dd-wrt etc.) disconnected, connect the modem/router directly to your PC and ensure that you can satisfactorily achieve a connection using the PC's PPPoE client.
2. Next, set up the downstream router to make a PPPoE connection and connect it the modem/router.