A forum to discuss the Gargoyle web interface for Openwrt
https://www.gargoyle-router.com/phpbb/
I never ran that swap command and once I formatted the drive correctly I never had any problems, plug and play ?I have also rebooted but it did not work before I ran mkswap... afterwards, I rebooted, to make sure that it was still working and it is working fine
Code: Select all
usb 1-1: new high speed USB device using ar71xx-ehci and address 6
usb 1-1: configuration #1 chosen from 1 choice
scsi0 : SCSI emulation for USB Mass Storage devices
scsi 0:0:0:0: Direct-Access TOSHIBA TransMemory 1.00 PQ: 0 ANSI: 2
sd 0:0:0:0: [sda] 7823296 512-byte logical blocks: (4.00 GB/3.72 GiB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] Assuming drive cache: write through
sda: sda2 < sda5 sda6 >
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] Attached SCSI removable disk
Adding 122872k swap on /dev/sda5. Priority:-1 extents:1 across:122872k
Adding 122872k swap on /dev/sda5. Priority:-1 extents:1 across:122872k