Gargoyle Forum

I noticed this user had success using Gargoyle with your router.

http://www.gargoyle-router.com/phpbb/vi ... f=6&t=1108

So I suspect this is a version issue with this hardware.

Since I do not have this router I cannot work on this problem. I doubt that Eric has it either.

If you can work on it and find the issue then I can get your fix into the next build.

This router has a really weird switch configuration which. I think there is another thread in the troubleshooting forum which discusses this. The switch is really unique, different from all the other similar routers, so supporting it is going to require special handling. OpenWRT does support the router, but configuring the network on it requires very different settings than on other routers, so you're seeing flaky results.

DoesItMatter wrote: http://www.dd-wrt.com/phpBB2/viewtopic.php?t=85237

hellbound - follow that link - login to dd-wrt to see the firmwares

revert back to factory firmware on your tplink

reset to defaults

flash to gargoyle 1.3.10, then see if you can login

only thing I can think to try out

well the new build is not tweaked for the weird switch configuration of TP-link. I have already reverted back to default firmware couple of times to install gargoyle in 1.3.9 though. But the problem will persist as said by eric

pbix wrote:I noticed this user had success using Gargoyle with your router.

http://www.gargoyle-router.com/phpbb/vi ... f=6&t=1108

So I suspect this is a version issue with this hardware.

Since I do not have this router I cannot work on this problem. I doubt that Eric has it either.

If you can work on it and find the issue then I can get your fix into the next build.

i dont know the build of this user may be ver 1.xx higher version having this issue. i m interested about this thread

http://www.gargoyle-router.com/phpbb/vi ... 5173#p5173

i can see the user is replying with all the answers but at last no reply from admins about the problem. well if dd-wrt can run on my switch then gargoyle should also. dd-wrt's/openwrt source code is open i guess you can use that for switching problem.

Eric wrote:This router has a really weird switch configuration which. I think there is another thread in the troubleshooting forum which discusses this. The switch is really unique, different from all the other similar routers, so supporting it is going to require special handling. OpenWRT does support the router, but configuring the network on it requires very different settings than on other routers, so you're seeing flaky results.

so that means there was no workaround for this switching problem in new version 1.3.10 ?

I Have the same problem with my TP-Link TL-WR841ND v3.

I reported this problem here http://www.gargoyle-router.com/phpbb/vi ... f=6&t=1193 because I didn't find in this forum any problems like this, related to my model, but it seems that it has similar harware with the one you are talking about:



Regards,

Helder