Re: TP-Link WR1043ND stock firmware -> to Gargoyle
Posted: Sun Nov 14, 2010 12:03 am
Tried all the suggestions but all the firmware loads I tried came up with "no space left on device"
Finally bricked the 1043ND by mistyping a command I think.
Went to tftp with serial and managed to load open-wrt then upgraded to Gargoyle 1.3.7, appears to work !
Memory usage is running at a constant 25.4mb now which to me is a bit high, is this right or how can I reduce this figure ?
Finally bricked the 1043ND by mistyping a command I think.
Went to tftp with serial and managed to load open-wrt then upgraded to Gargoyle 1.3.7, appears to work !
Memory usage is running at a constant 25.4mb now which to me is a bit high, is this right or how can I reduce this figure ?