Page 2 of 3
Re: WDS in 1 network? possible??
Posted: Wed May 11, 2016 3:27 am
by chiwing
where is there, LANTIS ?
post a picture plz
TKS
Re: WDS in 1 network? possible??
Posted: Wed May 11, 2016 3:56 am
by Lantis
http://imgur.com/WdsWYee
Set the Bridge IP to a different subnet to the network you want to repeat.
Set the Gateway/AP ip to the IP address of the gateway in the network you want to repeat.
Set the subnet mask to the same as the AP subnet mask.
Please be aware that the relay can take a minute to connect.
Re: WDS in 1 network? possible??
Posted: Mon May 23, 2016 2:25 am
by chiwing
Can u post a capture of screen to show where are the buttons ?
many thanks
Re: WDS in 1 network? possible??
Posted: Mon May 23, 2016 4:11 am
by Lantis
What buttons?
This section is immediately below where you choose between Gateway or Bridge
Re: WDS in 1 network? possible??
Posted: Fri Aug 05, 2016 2:12 am
by chiwing
Lantis wrote:Just update to the latest version I put it all in there. You can then just click some buttons and set it up.
Make sure when you set the router IP it is outside the subnet of the host.
https://www.youtube.com/watch?v=-Vi91fTqsEU
any more simpler method(like NAT) to view my colleugue's share folder
http://wiki.mikrotik.com/wiki/NAT_Tutorial
when C2 cmp under 2 router which is connect to wan port ( 192.168.0.X can read 192.168.5.X) ?
Re: WDS in 1 network? possible??
Posted: Fri Aug 05, 2016 5:07 am
by Lantis
It will (should) work fine because all of the devices end up on the same subnet.
Re: WDS in 1 network? possible??
Posted: Sat Oct 28, 2017 2:14 am
by chiwing
Lantis wrote:http://imgur.com/WdsWYee
Set the Bridge IP to a different subnet to the network you want to repeat.
Set the Gateway/AP ip to the IP address of the gateway in the network you want to repeat.
Set the subnet mask to the same as the AP subnet mask.
Please be aware that the relay can take a minute to connect.
In the first post there is a picture: 841N & 741ND:
741ND is Bridge, 841N is Gateway/AP , right?
Do I need to flash 841N & 741ND to openwrt?
or just need to flash to be gargoyle ?
( my aim is let all device in one same network , so all device can get IP automatically and see each other
Thanks
Re: WDS in 1 network? possible??
Posted: Sat Oct 28, 2017 4:57 am
by ispyisail
Re: WDS in 1 network? possible??
Posted: Sat Oct 28, 2017 6:27 am
by chiwing
its seems that I only need to flash WR741ND to be gargoyle !
Re: WDS in 1 network? possible??
Posted: Sat Oct 28, 2017 10:01 am
by chiwing
chiwing wrote:
its seems that I only need to flash WR741ND to be gargoyle !
I want to ask :
relayD , does it have delay ?
Do i only need to flash gargoyle to WR741ND, then the last IP camera that receive signal from wr741ND can get IP address 10.10.179.X ?
THANKS