Page 2 of 2
Re: No 3G config mr3420
Posted: Mon Sep 01, 2014 2:08 am
by SwidWin
pbix wrote:
I suppose it could be that due to your routers lack of FLASH that the Gargoyle image is built without the required modules. You should check.
If add support for 3G in the current firmware for mr3420 it difficult,
then may be free up space for the installation of the module
USB Storage Support for Gargoyle.
USB Storage Support for Gargoyle Module Required Disk Space 5,249 MBytes and 16 megabyte flash drive it should fit.
Re: No 3G config mr3420
Posted: Thu Feb 25, 2016 7:19 am
by stancafe
The MR3420 original firmware sucks. Change it to Open WRT as in this tutorial. It saved my life, the router work much better and the 3g back link is great
Link removed by admin.
Comment: seems a bit spammy and can't confirm legitimacy of firmware.
Re: No 3G config mr3420
Posted: Fri Feb 26, 2016 3:52 pm
by ispyisail
stancafe wrote:The MR3420 original firmware sucks. Change it to Open WRT as in this tutorial. It saved my life, the router work much better and the 3g back link is great
Do you make this firmware?
Re: No 3G config mr3420
Posted: Tue Jan 30, 2018 2:11 am
by sqgl
Bump.
Joined this forum just to find out.
Re: No 3G config mr3420
Posted: Tue Jan 30, 2018 3:40 am
by Lantis
As per the previous responses, no. There is not enough flash space.
You could try a firmware from eko.one.pl which may have squeezed it in.
Re: No 3G config mr3420
Posted: Tue Jan 30, 2018 11:00 pm
by sqgl
Thanks. The hardware is now up to v5 (which is what I have) but regardless of whether it now has enough memory it is not supported by Open-WRT. Only v2 supports 4G modems and Open-WRT.