Gargoyle Forum

yes

It has all the images included

I think its about 1 gig uncompressed

I cant get it to upgrade. I am using the "sysupgrade.bin" file (using this exact wording). All the leds on the router do all different types of flash codes and then after a little while the first 3 leds remain on constantly while the 4th one does a flicker constanltly ( not necessarily a repetive flicker it does alter slightly). The pc has a window on the screen saying "Upgading please wait" so I left it doing that for about 5mins after the first 3 leds stop flashing. So then I refreshed the gargoyle management page and logef in again to find it was still saying version1.8.
Should i try the squashfs-factory.bin file? And how do I go about that?

Stupid question maybe but have you rebooted the modem after you swap routers? When my cable router is in modem mode and I swap routers if I don't reboot the "modem" I have no internet access. The cable network sees the change of mac address of my router and assigns a different ip address when I reboot the modem after swapping the routers. If I put the original router back without rebooting it happily gives an internet connection again. Might not be an issue with your set up but worth trying.

Hey Rog66, so I'll give that a go and see what happens.

Hey Rog66, I got it working... but it wasn't what you said.. I went into the Connections --> Basic. Changed the "Internet/Wan to DHCP (wired) and Released the DHCP and then Renewed it.. So it came back as the IP addresses that my ISP uses and it put a Current Lease Expire of 27.01.2017 AEST.

so now I have the internet working.. woohoo, am I able to set IP addresses to the devices/PC's that connect to my network.
Before I flashed the router to gargoyle I was able to set a specific IP addresses to my devices Mac address.
How can I do that now?

arh yes, thank you ispyisail, the blocking box at the top of this section put me off.
I have now set up all my IP's now