Page 2 of 2
Re: Archer C7 v2 Client Mode issue
Posted: Sun Jan 22, 2017 2:36 am
by Lantis
Perfect. As predicted, just a display issue. Will see if i can hunt it down.
Re: Archer C7 v2 Client Mode issue
Posted: Sun Jan 22, 2017 2:42 am
by De-Lemon
Again thanks for the hard work. I really like the firmware. Tried DD-WRT and did not like the interface. OpenWRT was just too confusing.
Re: Archer C7 v2 Client Mode issue
Posted: Sun Jan 22, 2017 7:14 pm
by De-Lemon
Is it possible to configure the DHCP address on the wireless router connection to router 1?
If not will put in a reservation so i know where it is.
Re: Archer C7 v2 Client Mode issue
Posted: Mon Jan 23, 2017 2:22 am
by Lantis
No it is pure DHCP, you're at the whim of the other router.
It is probably wise to give it a reservation.
Re: Archer C7 v2 Client Mode issue
Posted: Mon Jan 23, 2017 2:59 am
by ispyisail
whim of the other router
a fancy whim, from my understanding Eric has put some code that the router tries to create a IP from the MAC address if possible.
assuming the other router is Gargoyle router of cause.
Re: Archer C7 v2 Client Mode issue
Posted: Mon Jan 23, 2017 7:43 am
by Lantis
https://github.com/ericpaulbishop/gargoyle/pull/596
Have made the Relay IP easier to find (on the main status page)
Have also tracked down and fixed the bug causing the interface to not match the config.
Re: Archer C7 v2 Client Mode issue
Posted: Fri Jan 27, 2017 5:10 am
by De-Lemon
Ahh cool just looked at the changes. Will try them out once i get a chance. Unfortunately my primary router is a R7800 and not supported by most open source (yet, still early) or i would have Gargoyle on it.