IS TP-LINK WR340G SUPPORTED BY GARGOYLE

[freakazoid]

Hello i have a tp-link wr340g running openwrt kamikaze 8.09.2 i flashed openwrt to use this router as a client bridge but then learned that openwrt does not support client bridge on atheros chipset so i retired in using routed client masquerade method but i do not like this so much and would like to us a real bridge so i came across arp-nat so i decided to see whether gargoyle will be supported by my router

here are my specs
CPU is a atheros ar2317-ac1a
FLASH is a mx 25l1605 (2mb)
(it has 2mb flash is that what is the minimum amount for ur firmware i just want it to act as a repeater everything else can go like firewall etc for a custom build)

RAM is esmt m12l64164a- 8mb
SWITCH marvell 88e6060-rcj1

ps as i said earlier i have openwrt kamikaze 8.09.2 build installed with redboot bootloader

[freakazoid]

anyone? is there a custom build with just driver so client bridge via arp-nat is possible the gui can go

[pbix]

Gargoyle is based on OpenWRT.

Did you try an OpenWRT backfire release?

If OpenWRT does not work then its doubtful that Gargoyle would either.

[freakazoid]

it has only a 2mb flash i guess that is not enough at all