Version 1.9.1

[Lantis]

installed 1.9.1. on WNDR 3700v2
seems working ok

When I create backup than under file wireless there is non crypted wireless key. It is possible to crypt it?

Under host file I got 2 record for my LAN gargoyle is default, but i usually change name of router to routr.

192.168.1.1 Gargoyle
192.168.1.1 routr

speed is ok 95/95 from 100/100

thank you

No. It's stored unencrypted on the router.
It's not likely you're storing or sending your backups anywhere insecure.

[Lantis]

Model:TP-Link TL-MR3220 v2 - work fine!
At first glance, there are some flaws...
Required Disk Space fo Plugin show in MBytes instead KBytes


UTC time is displayed uncorrectly (for some countries)...
Russia must be UTC + 3 (if you take the time in Moscow, as the capital).

You don't have enough disk space to install plugins, so a dependency was removed in order to prevent you doing so. The dependency is approximately 13MB if installed later.
This isn't an error.

11 time zones in Russia.
I agree with you that the one including the capital should probably be the one labelled as "Russia". I'll add it to my todo list.

[pc168]

WNDR 3700v4
Upgraded from 1.8.1 to 1.9.1
Did not preserve settings (not supported anyway)
So far so good

[caeci11ius]

How's the routing performance in the new version? Anyone seeing differences? I note some folks are hitting 100/100 or close to it with some fairly old hardware, but I'm guessing that's not simultaneous transfers with QoS enabled?

[out of rules]

traceroute to google.com (89.218.72.108), 30 hops max, 38 byte packets
1 Bridge (192.168.1.2) 0.934 ms Bridge (192.168.1.2) 0.519 ms 0.524 ms
2 MainRouter (192.168.1.1) 1.722 ms 1.648 ms 1.568 ms
3 MainRouter (192.168.1.1) 2.021 ms 1.642 ms 1.613 ms
~ #

No internet on bridged clients

main router - gargoyle 1.9.1
bridge - ddwrt

On 1.8.1 everything was fine

[Lantis]

Please check your bridge config. The requirements have changed slightly.
If you preserved your config, this will definitely have broken it.

Please start a separate thread if you are still stuck and we will get you sorted.

[pwiktorczyk]

Hello,

I upgraded today my TP LINK WR1043ND to 1.9.1 and it stopped working. I'm not able to start router, factory reset doesn't work. Any solution to start it?

[Lantis]

Failsafe reset

[pwiktorczyk]

Could you explain what fail safe reset mean and how to proceed?

[ispyisail]

Could you explain what fail safe reset mean and how to proceed?

google "Openwrt failsafe reset"