Version 1.6.0

siluah · Post by **siluah** » Fri Jan 17, 2014 10:32 pm

How long does it usually take for a new version to show up on git? I tried cloning and the build still says 1.5.

Dev_BR · Post by **Dev_BR** » Fri Jan 17, 2014 11:44 pm

Postby tapper » Thu Jan 16, 2014 5:50 pm
Hi Wireless MAC Filtering is the job of your access point not the repeater.

I think Wireless Mac filter is a lower layer and have to be done on both AP and repeater

I can say you, if I Filter MAC on AP, people withot permission still can connect to repeater

marcb · Post by **marcb** » Sat Jan 18, 2014 3:13 pm

Did you bump OpenWRT build to latest version?

Post by **tapper** » Sat Jan 18, 2014 5:40 pm

CBx86 · Post by **CBx86** » Sat Jan 18, 2014 8:46 pm

Niceeee!!!

Someone has already tested in the TL-WDR4300 v1.x?

Many thanks!

coits · Post by **coits** » Sun Jan 19, 2014 12:40 am

FYI,

Confirmed preserving settings from 1.5.11 to 1.6.0 works.

Thank you all.

buddee · Post by **buddee** » Sun Jan 19, 2014 5:16 am

Router: wzr-hp-g300nh v1
This build still has client+ap mode problems as reported in the last official build thread. After some given time, the bridge will loose connection to the host ap until i go into connection>basic and click 'save changes', I don't have to change anything in there from the original config, just 'save changes' and works again. It'd be nice not to have to do that though.

Last build with a working client+ap mode was 1.5.6

lceron80 · Post by **lceron80** » Tue Jan 21, 2014 12:36 am

hello, just upgraded to the 1.6.0 version and it is giving me this weird error

http://ubuntuone.com/7HJQwMzOgJLJyGY53mUXD3

i have tried wifi and cable and same message,

any suggestions?

i have only https access to the router login

ptnull · Post by **ptnull** » Tue Jan 21, 2014 6:35 am

So far it's working fine for me on tplink TL-WR841N/ND v8, working as gateway.

Thanks

mtr · Post by **mtr** » Tue Jan 21, 2014 9:01 am

lceron80 wrote:hello, just upgraded to the 1.6.0 version and it is giving me this weird error

http://ubuntuone.com/7HJQwMzOgJLJyGY53mUXD3

i have tried wifi and cable and same message,

any suggestions?

i have only https access to the router login

The URL is malformed and it should be https://192.168.1.1:444/login.sh.

That bug has been reported previously here (http://www.gargoyle-router.com/phpbb/vi ... =10#p22095)

Maybe there is an error in URL building.

Gargoyle Forum

Version 1.6.0

Re: Version 1.6.0

Re: Version 1.6.0

Re: Version 1.6.0

Re: Version 1.6.0

Re: Version 1.6.0

Re: Version 1.6.0

Re: Version 1.6.0

Re: Version 1.6.0

Re: Version 1.6.0

Re: Version 1.6.0