Open VPN GUI
Moderator: Moderators
Re: Open VPN GUI
Yes, I am aware of the port forwarding requirements. If you look at my post from March 17th of 2011 (http://www.gargoyle-router.com/phpbb/vi ... =vpn#p5931), I state the following: "I forwarded the necessary ports (1723,500) to the correct IP"hnl_dk wrote: for PPTP VPN
TCP Port 1723
UDP Port 500
for L2TP VPN
TCP Port 1701
UDP Port 500
for IPSec
UDP Port 500
And ispyisail:
Yes, I found this article a while back and tried to follow it. He was using an older OpenWRT version so some of the packages have combined and/or changed names. I can get all of the packages to install correctly, but the kernel modules fail to load either via reboot or "insmod" commands. I've gone on several package installation rampages in attempt to get lucky enough to grab the missing symbols, but I always come up shortispyisail wrote:this is the best i could find
http://www.blackmanticore.com/51f359dfe ... 633e2e7c2b
"PPTP uses IP protocol 47, designed for "General Routing Encapsulation" or GRE packets. A common mistake in configuring firewalls for use with PPTP is to open PPTP port 1723 (allowing connections to be established) but forget to forward GRE protocol type 47 (denying port data from passing through the tunnel)."
-- I can't get the kernel modules responsible for forwarding the GRE protocol to load!!
"lsmod | grep -i gre" comes up empty.
- DoesItMatter
- Moderator
- Posts: 1373
- Joined: Thu May 21, 2009 3:56 pm
Re: Open VPN GUI
See here:
https://forum.openwrt.org/viewtopic.php?id=27777
and here:
http://wiki.openwrt.org/doc/howto/vpn.nat.pptp
Is this the new module?
kmod-ipt-nathelper-extra
https://forum.openwrt.org/viewtopic.php?id=27777
and here:
http://wiki.openwrt.org/doc/howto/vpn.nat.pptp
Is this the new module?
kmod-ipt-nathelper-extra


2x Asus RT-N16 = Asus 3.0.0.4.374.43 Merlin
2x Buffalo WZR-HP-G300NH V1 A0D0 = Gargoyle 1.9.x / LEDE 17.01.x
2x Engenius - ESR900 Stock 1.4.0 / OpenWRT Trunk 49400
Re: Open VPN GUI
Did you install kmod-gre ?
Router: TL-WR1043ND - Gargoyle 1.5.4
AP: TL-WR1043ND - Gargoyle 1.5.4
AP: TL-WR1043ND - Gargoyle 1.5.4
Re: Open VPN GUI
DoesItMatter wrote:See here:
https://forum.openwrt.org/viewtopic.php?id=27777
and here:
http://wiki.openwrt.org/doc/howto/vpn.nat.pptp
Is this the new module?
kmod-ipt-nathelper-extra
Yes, if you look at my December 9th post: http://www.gargoyle-router.com/phpbb/vi ... =vpn#p9254 you will see that I do the following:
Code: Select all
opkg install kmod-ipt-conntrack kmod-ipt-conntrack-extra kmod-ipt-nat kmod-ipt-nat-extra kmod-ipt-nathelper [b]kmod-ipt-nathelper-extra[/b]
opkg install pptp pptpd
Yes, I have installed kmod-gre too (even though it's not listed in the original package list above) -- still can't get the modules to load.hnl_dk wrote:Did you install kmod-gre ?
Would anyone else be willing to try installing any/all of these packages to see if they can get any of the "gre" modules to load?
Re: Open VPN GUI
We really need VPN on gargoyle
Buffalo WZR-HP-G300NH2 DD-WRT v24SP2-MULTI (10/31/11) std
Buffalo WZR-HP-G300NH Gargoyle 1.5.9+1f082daf
Linksys WRT54GL Gargoyle 1.4.4
TP-Link TL-WR1043ND Gargoyle 1.5.9+1f082daf
Buffalo WZR-HP-G300NH Gargoyle 1.5.9+1f082daf
Linksys WRT54GL Gargoyle 1.4.4
TP-Link TL-WR1043ND Gargoyle 1.5.9+1f082daf
Re: Open VPN GUI
Looks like this is the next new big feature
Re: Open VPN GUI
yesispyisail wrote:Looks like this is the next new big feature

Buffalo WZR-HP-G300NH2 DD-WRT v24SP2-MULTI (10/31/11) std
Buffalo WZR-HP-G300NH Gargoyle 1.5.9+1f082daf
Linksys WRT54GL Gargoyle 1.4.4
TP-Link TL-WR1043ND Gargoyle 1.5.9+1f082daf
Buffalo WZR-HP-G300NH Gargoyle 1.5.9+1f082daf
Linksys WRT54GL Gargoyle 1.4.4
TP-Link TL-WR1043ND Gargoyle 1.5.9+1f082daf
Re: Open VPN GUI
Hi everyboby!
Are there news about the implementation of a VPN servere in Gargoyle?
In case it would be great to implement a protocol supported by the smartphones (iPhone, iPod, Android)
I will follow this topic!
Are there news about the implementation of a VPN servere in Gargoyle?
In case it would be great to implement a protocol supported by the smartphones (iPhone, iPod, Android)
I will follow this topic!
Tp-Link WR1043ND v1.4 using Gargoyle 1.7.2
Tp-Link WDR3600 v1.5 using OpenWRT CC by SamKnows

Tp-Link WDR3600 v1.5 using OpenWRT CC by SamKnows
