WR841N v5 wireless 130Mbps only

Report wireless and/or network connectivity problems in this forum.

Moderator: Moderators

Post Reply
cn008
Posts: 24
Joined: Tue Jan 24, 2012 3:54 pm

WR841N v5 wireless 130Mbps only

Post by cn008 »

Hi I flashed my router with the stable version 1.4.5, and now wireless is only 130Mbps.

I have tried this using SSH but it did not work:

uci set wireless.radio0.noscan=1
uci commit
reboot

This solution was discussed here: https://forum.openwrt.org/viewtopic.php?id=30315

I guess I can live with 130Mbps, but is there any solution to get it to 300M?

Thanks.

User avatar
nicram
Posts: 29
Joined: Fri Dec 23, 2011 6:27 pm
Location: PL
Contact:

Re: WR841N v5 wireless 130Mbps only

Post by nicram »

Did it work with 300Mb/s with default firmware? what is Your connection configuration (i mean wireless settings)?
Have You setup to use 40Mhz? (only then it will work with full speed)
TL-WR1043ND HW v1.8 | FW Gargoyle 1.5.X (Built 20120504-1907 git@2bf3cf2) | 2 Mbit | PPPoE

cn008
Posts: 24
Joined: Tue Jan 24, 2012 3:54 pm

Re: WR841N v5 wireless 130Mbps only

Post by cn008 »

Hi Thanks for replying.
I actually did not notice the speed on factory firmware. I should have checked it before upgrading.

Also I lost internet connectivity while connected via LAN to the router, however wireless seems to be ok.

And I tried to download using both LAN and wireless connection, there is no big difference in speed so I think 130Mbps is still ok.

My wireless setting is: 40MHz(2nd channel above) and channel is 6, tx power is 13dbm, and WPA2 encryption.

User avatar
nicram
Posts: 29
Joined: Fri Dec 23, 2011 6:27 pm
Location: PL
Contact:

Re: WR841N v5 wireless 130Mbps only

Post by nicram »

Try to use channel 3. About speed, it may depend on wificard inside computer. What wifi card is it?
TL-WR1043ND HW v1.8 | FW Gargoyle 1.5.X (Built 20120504-1907 git@2bf3cf2) | 2 Mbit | PPPoE

mix
Posts: 292
Joined: Sun Feb 27, 2011 11:18 am

Re: WR841N v5 wireless 130Mbps only

Post by mix »

cn008 wrote:My wireless setting is: 40MHz(2nd channel above) and channel is 6, tx power is 13dbm, and WPA2 encryption.
Unless you have a specific reason for setting your tx power so low, I think you will be happier with the tx power set higher than 13.
WRT54GL v1.1
Gargoyle 1.4.7

cn008
Posts: 24
Joined: Tue Jan 24, 2012 3:54 pm

Re: WR841N v5 wireless 130Mbps only

Post by cn008 »

I have a wireless n card on my laptop.

I changed both tx power to max, and channel to 3, wireless became unstable for a few minutes, sometimes showing 117Mbps, sometimes no internet access, then stable @ 130Mbps.

I think tx power is only for the signal and while @ 13 the signal is still excellent.

Post Reply