reseting a router to default settings
Posted: Wed Nov 24, 2010 1:30 pm
I have a lovely WRT54G v2. I have installed Gargoyle on it and it worked fine in AP mode. I reconfigured it as a wireless bridge mode, following the instructions, but I can now not connect to it. I have tried the IP address I told it to be, and it does not respond (router and computer are on the same subnet).
I would like to now reset all configuration to the default settings. I have tried a 30-30-30 but that does not seem to have any impact. Is there a description somewhere of how to do such a reset?
I have looked through the documentation and I do not see it.
Thanks!
I would like to now reset all configuration to the default settings. I have tried a 30-30-30 but that does not seem to have any impact. Is there a description somewhere of how to do such a reset?
I have looked through the documentation and I do not see it.
Thanks!