Page 1 of 1

Downgrade gargoyle 1.6.1 (give problem)

Posted: Mon Jul 07, 2014 5:03 am
by maders
Firmware Version:
3.9.7 Build 090 821 Rel.38819n
Hardware Version:
WR941N v2/v3 00000000

I installed version gargoyle 1.6.1 (give problem)
I would take the version 1.5.11, the proper procedure to downgrade?

Can I factory with squashfs?
or do I have with sysupgrade?

thank you.

Re: Downgrade gargoyle 1.6.1 (give problem)

Posted: Wed Jul 09, 2014 2:37 am
by DoesItMatter
You can downgrade to the 1.5.11 version with the sysupgrade file

Make sure you reset to defaults first

And DO NOT save config - you have to re-configure fresh

Re: Downgrade gargoyle 1.6.1 (give problem)

Posted: Sun Jul 13, 2014 6:45 am
by maders
I followed your instructions, the update was successful, now v.1.5.11 gargoyle but I always find the antenna problem that goes off (gargoyle repeater) and I have to restore from the command line, type "wifi" any other suggestions? Thank you .........

root@Gargoyle:~# wifi
command failed: Device or resource busy (-16)
Configuration file: /var/run/hostapd-phy0.conf
Using interface wlan0 with hwaddr 00:25:86:d2:7f:a0 and ssid "DLINK"
Successfully initialized wpa_supplicant