Install gargoyle in Tecom from OpenWrt
Posted: Sun Feb 05, 2012 7:30 am
Hello, I want to install Gargoyle on my router. 
The Tecom AH2322W has a CPU Broadcom BCM6358VKFBG. There are also WiFi extensions that are handled by the chip on the main board and not a daughter card. The board ID shows as a 96358VW.
I've flashed it with openwrt-96358GW-squashfs-dsl2740b-cfe.bin by the Web interface in the stock firmware and it boots fine. Eth1 picks up an IP address from the DHCP server on the LAN, and I have installed and accessed Luci.
The problem is that I don't know what is the procedure, as there is a "new" router and there is no info for the installation.
Somebody could give me any hint? Thank you in advance!
Offtopic: Wondering if the wireless bridge (Wireless client+AP) can be achieved with this chip, which is my main purpose. Wondering also if the USB and VOIP connector that the router have, could be used with Openwrt
The Tecom AH2322W has a CPU Broadcom BCM6358VKFBG. There are also WiFi extensions that are handled by the chip on the main board and not a daughter card. The board ID shows as a 96358VW.
I've flashed it with openwrt-96358GW-squashfs-dsl2740b-cfe.bin by the Web interface in the stock firmware and it boots fine. Eth1 picks up an IP address from the DHCP server on the LAN, and I have installed and accessed Luci.
The problem is that I don't know what is the procedure, as there is a "new" router and there is no info for the installation.
Somebody could give me any hint? Thank you in advance!
Offtopic: Wondering if the wireless bridge (Wireless client+AP) can be achieved with this chip, which is my main purpose. Wondering also if the USB and VOIP connector that the router have, could be used with Openwrt