Page 1 of 1
Need help for my WZR-HP-G300NH
Posted: Sat Sep 10, 2011 1:16 am
by yc3948
I successfuly flashed my WZR-HP-G300NH today but it died after restore the configuration backup from my linksys WRT54GL. I tried to 30/30/30 but not working, and I also tried to reset by holding reset button for 10 secs also not working. Please help!
My WZR-HP-G300NH flashed gargoyle_1.4.1-ar71xx-wzr-hp-g300nh-squashfs-sysupgrade.bin
and my linksys WRT54GL flashed gargoyle_1.3.16-wrt54g-squashfs.bin
and the backup file is backup.tar.gz
Could you please let me know any solutions? Thanks very much.
Re: Need help for my WZR-HP-G300NH
Posted: Sat Sep 10, 2011 6:21 am
by pbix
Re: Need help for my WZR-HP-G300NH
Posted: Sat Sep 10, 2011 8:10 am
by yc3948
Thx but not working too...
Re: Need help for my WZR-HP-G300NH
Posted: Mon Sep 12, 2011 12:18 pm
by DoesItMatter
yc3948 wrote:I successfuly flashed my WZR-HP-G300NH today but it died after restore the configuration backup from my linksys WRT54GL. I tried to 30/30/30 but not working, and I also tried to reset by holding reset button for 10 secs also not working. Please help!
BAD BAD BAD idea...
You must NEVER flash a different config backup from a different router.
The only way this could be used is if you were backing up
Identical Hardware model and revisions
I.E. backup from a Linksys WRT54G-TM and restore to WRT54G-TM
Since you restored a Broadcom config backup to an Atheros device,
you will have to go in via Serial console and reload this firmware:
gargoyle_1.4.1-ar71xx-wzr-hp-g300nh-squashfs-tftp.bin
TFTP that via Serial Console and you should be OK
http://www.dd-wrt.com/wiki/index.php/Bu ... -HP-G300NH
Check that page and links in the page for recovery help.