D-LINK DIR-505 A2 - No WAN IP (latest build)

Report problems and success stories with Gargoyle on various hardware platforms.

Moderator: Moderators

Post Reply
SirSWE
Posts: 88
Joined: Sat Jul 13, 2019 2:54 pm

D-LINK DIR-505 A2 - No WAN IP (latest build)

Post by SirSWE »

I have tried 1.10 and 1.12 and I cant get WAN IP with these builds, (its just blank and shows only WAN MAC adress) but it works great on 1.8.1 and 1.7.0 build.. What wrong?

RomanHK
Posts: 794
Joined: Sat May 04, 2013 4:18 pm
Location: Czech Republik

Re: D-LINK DIR-505 A2 - No WAN IP (latest build)

Post by RomanHK »

You must not use a backup and always start from the default configuration for a new version - I know it's complicated, but maybe it will help you.
Turris Omnia with OpenWrt 21.02 - Tested
Linksys WRT3200ACM with Gargoyle 1.13.x
TL-WR1043ND v2 with Gargoyle 1.10.0

http://gargoyle.romanhk.cz custom builds by gargoyle users

SirSWE
Posts: 88
Joined: Sat Jul 13, 2019 2:54 pm

Re: D-LINK DIR-505 A2 - No WAN IP (latest build)

Post by SirSWE »

Do I need to install factory to gargoyle? I use sysupgrade when i upgrade between gargoyle and even reset didnt help.

SirSWE
Posts: 88
Joined: Sat Jul 13, 2019 2:54 pm

Re: D-LINK DIR-505 A2 - No WAN IP (latest build)

Post by SirSWE »

1.12 is also broken on dlink 825. Seems like 1.9.1 is working. Havent tried 1.9.2 :roll:

SirSWE
Posts: 88
Joined: Sat Jul 13, 2019 2:54 pm

Re: D-LINK DIR-505 A2 - No WAN IP (latest build)

Post by SirSWE »

I found a fix. I have to click "enable costum mac adress" then just save and it will start working. Works with 1.12 and latest 1.13x build. Really weird, but now its finally works. This issue is not on 1.9.2 firmware. It starts from 1.10 builds above on dlink 505. Haven't tried on 825 b1 yet.

Post Reply