Page 2 of 3
Re: Failed to build 1.12
Posted: Fri Sep 18, 2020 9:01 am
by raven
Re: Failed to build 1.12
Posted: Fri Sep 18, 2020 9:34 am
by Lantis
Config looks ok.
What command are you using to start the build?
Re: Failed to build 1.12
Posted: Fri Sep 18, 2020 10:33 am
by raven
I used command make ar71xx.glar150
Re: Failed to build 1.12
Posted: Fri Sep 18, 2020 9:22 pm
by Lantis
Try
make FULL_BUILD=true ar71xx.glar150
Without doing full build at least once, you don't get the patched kernel modules.
Re: Failed to build 1.12
Posted: Fri Sep 18, 2020 9:45 pm
by raven
If I use the full build when compiling, will the completed image will use the config I created?
Re: Failed to build 1.12
Posted: Fri Sep 18, 2020 10:25 pm
by Lantis
By config do you mean the build config which I assume you called ar71xx.glar150?
If so, yes.
If you're trying to pack custom Configs into /etc/config, no.
But, once you do one full build, you should be able to do follow up rebuilds using this technique.
Re: Failed to build 1.12
Posted: Fri Sep 18, 2020 11:53 pm
by raven
Ok, I'll try using full build and see what happened. I'll get back to you with the result later.
Re: Failed to build 1.12
Posted: Sun Sep 20, 2020 5:52 am
by raven
Hi Lantis, finally I managed to compile successfully, install and reboot. And now I have a problem that I just found, I haven't encountered any other problems besides this because of my limited time to test each function. I'll report it and ask again if I find it. For now the problem that I find is on the plugins page it says 'An Internet connection is required to Refresh Plugins' even though my router is connected to the internet and I can open websites. And when I press the refresh plugins button, the plugins are not refreshed but remain the same when they haven't been refreshed. Could this be because I made a mistake while compiling ?. Or is this normal and I have to install it manually?
Re: Failed to build 1.12
Posted: Sun Sep 20, 2020 8:03 am
by Lantis
Well done.
What connection method are you using on the Connection Basic page?
Re: Failed to build 1.12
Posted: Sun Sep 20, 2020 8:20 am
by raven
I'm using usb modem 4G (Hilink,RNDIS) configured as gateway