Bridge Mode - How to do it right

Report problems and success stories with Gargoyle on various hardware platforms.

Moderator: Moderators

SpudMuffin
Posts: 28
Joined: Tue Feb 06, 2018 5:37 pm

Re: Bridge Mode - How to do it right

Post by SpudMuffin »

OK, yes... I am viewing the upsteam router's DHCP client list and there is no IP listed, however, the gargoyle AP is working, but I can't access the gargoyle??

SpudMuffin
Posts: 28
Joined: Tue Feb 06, 2018 5:37 pm

Re: Bridge Mode - How to do it right

Post by SpudMuffin »

What do I need to do to access my gargyle now that I have it operating as you suggested?

Lantis
Moderator
Posts: 6721
Joined: Mon Jan 05, 2015 5:33 am
Location: Australia

Re: Bridge Mode - How to do it right

Post by Lantis »

If your upstream is not showing it as a client then what static IP did you set for it?
http://lantisproject.com/downloads/gargoyle_ispyisail.php for the latest releases
Please be respectful when posting. I do this in my free time on a volunteer basis.

SpudMuffin
Posts: 28
Joined: Tue Feb 06, 2018 5:37 pm

Re: Bridge Mode - How to do it right

Post by SpudMuffin »

I only changed those things that you mentioned. However, over to the right on the config panel was 192.168.1.1,255.255.255.0,192.168.1.1... tried that but no success either..

Since I did a full reset, is there a default?

ispyisail
Moderator
Posts: 5180
Joined: Mon Apr 06, 2009 3:15 am
Location: New Zealand

Re: Bridge Mode - How to do it right

Post by ispyisail »

screen shots would be very helpfull

SpudMuffin
Posts: 28
Joined: Tue Feb 06, 2018 5:37 pm

Re: Bridge Mode - How to do it right

Post by SpudMuffin »

Yes, but I can't access GUI so can't get SS....

ispyisail
Moderator
Posts: 5180
Joined: Mon Apr 06, 2009 3:15 am
Location: New Zealand

Re: Bridge Mode - How to do it right

Post by ispyisail »

failsafe reset and start again

SpudMuffin
Posts: 28
Joined: Tue Feb 06, 2018 5:37 pm

Re: Bridge Mode - How to do it right

Post by SpudMuffin »

How do I set static IP? or choose DHCP?

Lantis
Moderator
Posts: 6721
Joined: Mon Jan 05, 2015 5:33 am
Location: Australia

Re: Bridge Mode - How to do it right

Post by Lantis »

When you set connect via to disabled you can enter an IP address for the router.
http://lantisproject.com/downloads/gargoyle_ispyisail.php for the latest releases
Please be respectful when posting. I do this in my free time on a volunteer basis.

SpudMuffin
Posts: 28
Joined: Tue Feb 06, 2018 5:37 pm

Re: Bridge Mode - How to do it right

Post by SpudMuffin »

Does it have to be the same subnet? If so, that is where I made my mistake earlier....

Post Reply