1043ND V2 to V3 issues

mortenhoe · Post by **mortenhoe** » Sat Apr 08, 2017 9:15 am

I have a 1043ND V3. There was no official V3 gargoyle firmware at the time, so I successfully installed gargoyle firmware for the V2 on my V3.

Now that there IS an official V3 gargoyle firmware, I would of course like to install that. But I cannot seem to find others in my type of situation on this board.

Any help? Would be nice, if it was easy.

I of course tried to use the V3 sysupgrade on my 1.9.1 V2. It says upgrading in a white box, but nothing ever happens.

Post by **Lantis** » Sat Apr 08, 2017 6:08 pm

You may need to force the sysupgrade from the command line
sysupgrade -F

Also while there is probably no difference, I'd go a clean flash with the factory Gargoyle firmware as well just in case.

Don't preserve any settings.

jk2121 · Post by **jk2121** » Mon Jan 15, 2018 1:16 pm

I am needing to do the same thing. Were you able to get yours to work? What steps did you follow? Thank you.

mortenhoe · Post by **mortenhoe** » Mon Jan 15, 2018 3:01 pm

Nope. I'm still running V2 on my V3.

Post by **ispyisail** » Mon Jan 15, 2018 3:05 pm

???

Post by **ispyisail** » Mon Jan 15, 2018 3:07 pm

failsafe reset then install v3?

Post by **Lantis** » Mon Jan 15, 2018 3:56 pm

May need to return to OEM first

Gargoyle Forum

1043ND V2 to V3 issues

1043ND V2 to V3 issues

Re: 1043ND V2 to V3 issues

Re: 1043ND V2 to V3 issues

Re: 1043ND V2 to V3 issues

Re: 1043ND V2 to V3 issues

Re: 1043ND V2 to V3 issues

Re: 1043ND V2 to V3 issues