Back to Stock Firmware

[Nathansz]

Unfortunately I have to return my TP-Link WR1043ND back to the store with the original firmware, its a long story. Just when I got it working well!

How would I go about getting back to stock firmware, obviously you cant just "upgrade" from the web ui. Would I upgrade to openwrt and then back to stock firmware? not sure if this would work because ive never used open wrt but I remember reading that somewhere.

Can anyone steer me in the right to direction?

[Cezary]

Download this file: http://ecco.selfip.net/tl-wr1043nd-luci ... ig.bin.zip , unzip and flash via gui.

[Nathansz]

thanks

[Bthree]

All good, Ta

[nikil511]

link does not work anymore

Are these the same as the one on the TP-LINK site ?
Or will these brick the router ?
http://www.tp-link.com/support/download ... L-WR1043ND

I found another source for stock firmware:

http://samiux.blogspot.com/2010/03/howt ... 043nd.html
Can I use this via the GUI as well ?

Thanks

[Bthree]

http://samiux.blogspot.com/2010/03/howt ... 043nd.html
Can I use this via the GUI

That one will work and yes as Cezary says, use GUI

[nikil511]

Thanks! it did work...

For the record:
I wanted to do some USB HDD transfer tests with the stock firmware.
I get 6-4MB/sec on LAN , and only 600-800kb/sec on WAN ...

[Nathansz]

Is this suprising to you? I get similear wan speeds

[bigg]

Nice topic , I'm going to return to the factory firmware

[vplessky]

Nice topic , I'm going to return to the factory firmware

Looking forward to see you back with Gargoyle installed