Page 4 of 4

Re: IMQ@NAT kernel modul issue

Posted: Sun May 26, 2019 6:57 pm
by Lantis
This execution path doesn’t exist in the new patch, please trace it out.
This occurred because in the old patch it also returned 0 so no error.
Now it will either return success or failure, not both.

Re: IMQ@NAT kernel modul issue

Posted: Mon May 27, 2019 1:55 am
by RomanHK
Brings the first build test results from your repository. Perfect ;) .

Linksys WRT3200ACM = (10x restart without QoS, 20x restart with QoS) = O.K.
Turris Omnia = (5x restart without QoS, 20x restart with QoS) = O.K.

I already see success because you managed to get NAT first and then IMQ as needed. Good job +1.

I will continue to test and report any changes here. Thank you.

Re: IMQ@NAT kernel modul issue

Posted: Mon May 27, 2019 2:39 am
by Lantis
Thanks. I’ll wait a bit longer but then will probably push that fix through.

Re: IMQ@NAT kernel modul issue

Posted: Mon May 27, 2019 6:54 pm
by tester
Lantis wrote:It doesn't load at boot, but loads when needed.


Is it just 46-ipt-imq removed or there is something else?

Re: IMQ@NAT kernel modul issue

Posted: Mon May 27, 2019 8:08 pm
by Lantis
That’s all

Re: IMQ@NAT kernel modul issue

Posted: Sun Feb 02, 2020 1:32 pm
by CBx86
Hey guys! How are you doing? :D

Just update to 1.12.0@NETGEAR WNDR4300.

Set lan ip, masq, config QoS, pppoe, wifi and reading the log:

rmmod: module is not loaded


No warm?

Many thanks!

Re: IMQ@NAT kernel modul issue

Posted: Sun Feb 02, 2020 4:12 pm
by RomanHK
Greetings also ...
I don't have such reports. When I searched the net, I found that this command was deleting kernel modules - I suppose it's harmless ( https://linux.die.net/man/8/rmmod ).

Re: IMQ@NAT kernel modul issue

Posted: Sun Feb 02, 2020 4:36 pm
by Lantis
There is no problem

Re: IMQ@NAT kernel modul issue

Posted: Sun Feb 02, 2020 4:45 pm
by CBx86
Many Thanks, Guys!

Have a nice week. :D