Loosing QOS configs when saving while in "init"

If your problem doesn't fall into one of the other categories, report it here.

Moderator: Moderators

Post Reply
dsalch
Posts: 123
Joined: Wed Jan 06, 2016 2:09 pm
Location: Tx

Loosing QOS configs when saving while in "init"

Post by dsalch »

I have noticed this problem for the last couple versions but have not seen anything on it.

Scenerio:

1. Firewall QOS enabled
2. Make a change on the QOS page
3. Save settings
4. make another change on that or the other QOS page
5. save settings (must happen within a few seconds of #3)

result = all QOS rules erased

I am unsure of the exact timing for step 5, but it seems to be anytime during the "init" phase after saving settings the first time.

Lantis
Moderator
Posts: 6735
Joined: Mon Jan 05, 2015 5:33 am
Location: Australia

Re: Loosing QOS configs when saving while in "init"

Post by Lantis »

If you are using multiple tabs, this is guaranteed to cause a problem.
If you aren't, all i can suggest is slowing your actions down a little.
http://lantisproject.com/downloads/gargoyle_ispyisail.php for the latest releases
Please be respectful when posting. I do this in my free time on a volunteer basis.

dsalch
Posts: 123
Joined: Wed Jan 06, 2016 2:09 pm
Location: Tx

Re: Loosing QOS configs when saving while in "init"

Post by dsalch »

not multiple tabs. Just anytime a QOS setting page is saved while the system is in "init" state seems to loose settings for qos, especially the rule definitions.

it is totally avoidable, yes, but with no warnings it is disappointing when an entire set is lost due to being a bit to quick.

Post Reply