Gargoyle on x86 generic

General discussion about Gargoyle, OpenWrt or anything else even remotely related to the project

Moderator: Moderators

Post Reply
henriquebelaz
Posts: 10
Joined: Tue Feb 24, 2015 8:50 pm

Gargoyle on x86 generic

Post by henriquebelaz »

Hello!

Is there any build for generic x86 computers?

The alix build gets stuck loading the kernel. By what I could find, the build asks for -3d..., which is present only in AMD processors.

All I could find was a rebuild from 1.6.2 but no ethernet is recognized.
(http://www.gargoyle-router.com/phpbb/vi ... =14&t=5777)

Also, is it possible to port Gargoyle QOS and ACC over to OpenWRT?
The way Gargoyle deals with packet scheduling beats any other firmware out there.

Thanks a lot.

norman
Posts: 3
Joined: Wed Jun 10, 2015 3:31 pm

Re: Gargoyle on x86 generic

Post by norman »

hi man.
i have test this version and only get working this:
download openwrt-x86-generic-combined-ext4.img.gz
decompress it convert to .vdi use VBoxManage convertfromraw --format VDI openwrt.img openwrt.vdi,
create a new vb without hdd and add the converted .vdi
In VirtualBox settings for network select following options:
Adapter 1 - Attached to: Internal Network or host only adapter
Adapter 2 - Attached to: NAT or Bridged adapter (under that choose your network card, which you use to connect t o internet)
in advanced select: intel pro 1000 desktop.
in serial ports: port 1 enable
ready run vb. next you need to configure the network in gargoyle.
After everything loads, execute following command:
vi /etc/config/network
If you don't know how to use vi look here: http://www.howtogeek.com/102468/a-begin ... ext-files- with-vi/
Delete everything and write following or just change lines, which are different (IP and netmask may have to be changed, based on your network, set static IP if there is no DHCP for LAN):
config interface loopback
option ifname lo
option proto static
option ipaddr 127.0.0.1 24
option netmask 255.0.0.0 25 26
config interface lan
option ifname eth1
option proto dhcp
config interface wan
option proto static
option ifname eth0
option ipaddr 192.168.1.1
option netmask 255.255.255.0
After that save everything and run following command:
/etc/init.d/network restart
internet and local connection should work, so you can use opkg or SSH into Gargoyle (you may need to ope n ports in firewall).
PD
the only thing that I could not run is the http luci I think not installed
I expect has helped you!
greetings

Post Reply