Page 1 of 1
Firmware for WHR-HP-G54
Posted: Wed Jan 07, 2015 5:52 pm
by chigo58
Eric, can you please guide me and recommend which stable firmware I should download for the good old Buffalo WHR-HPG54 BCM based router please?
would any of these do? or should i go with Backfire (10.03.1)
gargoyle_1.4.7-brcm47xx-squashfs.trx
gargoyle_1.6.2-brcm47xx-squashfs.trx
gargoyle_1.7.0-brcm47xx-generic-squashfs.trx
Thank you
Re: Firmware for WHR-HP-G54
Posted: Thu Jan 08, 2015 2:28 am
by DoesItMatter
http://wiki.openwrt.org/toh/buffalo/whr-hp-g54
See that post
1.4.7 would be your best bet
If you want to try - you could also try 1.5.6
1.5.7 and up uses attitude adjustment which causes
memory issues with 4mb flash/16mb ram devices
Re: Firmware for WHR-HP-G54
Posted: Thu Jan 08, 2015 2:41 am
by chigo58
Than you.
Re: Firmware for WHR-HP-G54
Posted: Wed Feb 11, 2015 1:11 pm
by sqlgeek
chigo58 wrote:Eric, can you please guide me and recommend which stable firmware I should download for the good old Buffalo WHR-HPG54 BCM based router please?
would any of these do? or should i go with Backfire (10.03.1)
gargoyle_1.4.7-brcm47xx-squashfs.trx
gargoyle_1.6.2-brcm47xx-squashfs.trx
gargoyle_1.7.0-brcm47xx-generic-squashfs.trx
Thank you
I am considering doing the same for my WHR-HP-G54 and was wondering which firmware you chose and if you had any problems or tips.
Re: Firmware for WHR-HP-G54
Posted: Wed Feb 11, 2015 4:32 pm
by chigo58
I migrated directly from tomato 1.28 to this firmware
Code: Select all
gargoyle_1.4.7-brcm47xx-squashfs.trx
and have no regrets so far. Stable and works like a champ
