Page 1 of 2
TL-WR902AC
Posted: Mon Mar 04, 2019 5:31 am
by Youbloub
Hello,
Does gargoyle actualy works on this router?
Thanks
Re: TL-WR902AC
Posted: Mon Mar 04, 2019 6:20 am
by Lantis
Are you talking about the V1 or the V3 device?
For the v1, i tried to make it work, however the partitions on the device made it very difficult. Even with all firmware options basically stripped out, it was not enough space.
For the v3, i have not tried yet. I have one sitting on my desk here but have not opened it. It has a higher chance of working due to the smaller wireless firmware bin in my opinion.
Re: TL-WR902AC
Posted: Mon Mar 04, 2019 6:54 am
by Youbloub
Edit : I have the v3
Gargoyle is based on openwrt right?
Perhaps I will try, but I will quit my home and need it working. I'm Always afraid to brick it.
I 'm fully satisfacted with gargoyle on my wdr3600, and official firmware doesn' t provide share from a usb thetering from gsm ( this permit me to preserve battery life)
According to openwrt wiki, v3 is:
MediaTek MT7628AN ramips mt76x8
Here:
https://downloads.openwrt.org/snapshots ... ps/mt76x8/
If there is no solution actually with gargoyle, I will try the openwrt tonight.
Re: TL-WR902AC
Posted: Mon Mar 04, 2019 10:21 am
by RomanHK
Re: TL-WR902AC
Posted: Mon Mar 04, 2019 3:29 pm
by Youbloub
Yeha, thanks you, I have see this. I can make without.
Re: TL-WR902AC
Posted: Mon Mar 04, 2019 4:04 pm
by Lantis
The wifi should be supported as of a month ago I think.
Re: TL-WR902AC
Posted: Tue Mar 05, 2019 8:18 am
by Youbloub
So, I'm flashing it following
https://patchwork.ozlabs.org/patch/887325/
I hope that 5ghz will works soon, and that gargoyle will be ported on this chipset too
Re: TL-WR902AC
Posted: Mon Jun 21, 2021 3:35 pm
by SvenFinn
Hello Guys,
have there been any updates to this? I really want to run Gargoyle on my TL_WR902AC V3, but i can't find a compatible firmware image.
Re: TL-WR902AC
Posted: Tue Jun 22, 2021 9:07 am
by pythonic
If you're in a position to attempt to compile the image yourself (e.g. by using a Linux VM) I have a target config that covers the WR902AC v3 I can make available from which I have built images (I was playing with a gl-mt300n v2). I'm not in a position ATM to make a build publicly available though.
Re: TL-WR902AC
Posted: Mon Jan 03, 2022 8:17 am
by pythonic
SvenFinn wrote: ↑Mon Jun 21, 2021 3:35 pm
I really want to run Gargoyle on my TL_WR902AC V3, but i can't find a compatible firmware image.
If you're still interested, you might want to look at the
experimental build I've made available.
