Revert WR1043ND v2.1 to stock firmware

General discussion about Gargoyle, OpenWrt or anything else even remotely related to the project

Moderator: Moderators

Post Reply
elarcangel
Posts: 8
Joined: Mon Mar 25, 2013 3:01 pm

Revert WR1043ND v2.1 to stock firmware

Post by elarcangel »

Hi, does anyone know if the procedure to revert to stock firmware with V2 also applies for 2.1?
Seen here: https://www.gargoyle-router.com/wiki/doku.php?id=revert
redirects you here where only v1 and v2 are available.
http://www.friedzombie.com/tplink-stripped-firmware/

I assume v2 is good for 2.x but unsure and want to confirm to avoid bricking my router.

thanks in advance.

ispyisail
Moderator
Posts: 5180
Joined: Mon Apr 06, 2009 3:15 am
Location: New Zealand

Re: Revert WR1043ND v2.1 to stock firmware

Post by ispyisail »

check the openwrt wiki

They have the best information

elarcangel
Posts: 8
Joined: Mon Mar 25, 2013 3:01 pm

Re: Revert WR1043ND v2.1 to stock firmware

Post by elarcangel »

Hi ispyisail, I was looking on the wiki but apparently there's no info about revert to stock. also checked on the forum and they mention some options but most of them point to an FTP that is still valid but not open anymore, requires user and password. Also, many processes are for bricked routers and require dismantling the RT and soldering which is not my case as I still can access over web interface.

Any help to find the right procedure and file to get back to stock using web interface will be greatly appreciated.

ispyisail
Moderator
Posts: 5180
Joined: Mon Apr 06, 2009 3:15 am
Location: New Zealand

Re: Revert WR1043ND v2.1 to stock firmware

Post by ispyisail »

"I assume v2 is good for 2.x but unsure and want to confirm to avoid bricking my router."
This is my understanding also

I don't know the answer to the best re-flashing procedure

Find what you think is the best procedure (via google) then cross your fingers.

or stick with openwrt/gargoyle

Post Reply