Gargoyle Forum

Unfortunately "sys" is not shining. Olny PWR is shining

ispyisail wrote:

I tried. It's not working

I can be tricky

I think there are some youtube clips on how to do it

keep trying

Fixes guest network routing by including proper ebtables module

Can you please explain what changes were incorporated in the guest network routing?

Lantis wrote:https://www.youtube.com/watch?v=_NqHpRHl8gQ

Thank you for all your answers, unfortunatelly is not working.
I tried youtube method and also with wireshark. It's not working.
Ping is not reaching the router.
Maybe it's time to change the device

pwiktorczyk wrote:

Lantis wrote:https://www.youtube.com/watch?v=_NqHpRHl8gQ

Thank you for all your answers, unfortunatelly is not working.
I tried youtube method and also with wireshark. It's not working.
Ping is not reaching the router.
Maybe it's time to change the device

google "serial cable for openwrt routers" or something like that

pwiktorczyk wrote:

Lantis wrote:https://www.youtube.com/watch?v=_NqHpRHl8gQ

Thank you for all your answers, unfortunatelly is not working.
I tried youtube method and also with wireshark. It's not working.
Ping is not reaching the router.
Maybe it's time to change the device

I am facing the same problem as pwiktorczyk. I also did the sysupgrade to 1.9.1 on my wr1043nd -> only the link & power leds are lighting up, no webshell access, no telnet access, no ping...

I am using gargoyle on that router since 1.5 and never had any problems upgrading until now. Maybe there is a problem with the firmware?

I checked the web for the failsafe boot, but according to the openwrt wiki one should push the button when the sys-led lights up..but as I mentioned before, only the pwr and link leds do..

So as of now my trusty 1043nd is bricked...

Go for a serial recovery.

Did the two people reporting "bricks" attempt to preserve settings?