Gargoyle Forum

Eric wrote:tals, hnl_dk: The router is only rebooted in a few very rare cases.

However, for some (but not all) sections, the network needs to be restarted after settings are saved which does involve a connection drop. The network should come right back up afterwards, though.

Yes that is correct - seems to have been extended to more areas, or may just be my impression but QOS amendments and restrictions now cause an internet drop. QOS is fine, the restrictions is a little bit of a pain as I may want to terminate the childrens connection (which I do by having a always on rule which I disable/enable) whilst in a game but the spike will throw me out.

But understood if this is required

Is it just me or i just lost lots of configuration going from 1.5.3 to 1.5.4. I dont have a DHCP under connection anymore and i dont have portforward and restriction under firewall anymore

What i did is a gargoyle_1.5.4-ar71xx-wndr3700-squashfs-sysupgrade.bin to the new veresion and restored the previous backup.tar.gz right after.

Thanks!

Yep I experienced the same issue - the fix to stop losing the config also didn't seem to work, just decided to load the firmware again and redo from scratch rather than restore and that resolved.

Works great on TL-WR941ND. Thanks Eric and others.

I want to know about the support condition for Asus RT N-16 as people are running openwrt on it well not officially but it is working. Eric do you mind looking on that ? Asus RT N-16 is supported by Debwrt. There are many users like me who are eagerly waiting for openwrt support for this device. Here is the working firmware

https://dev.openwrt.org/ticket/6580

http://openwrt.razvi.ro/attitude_adjust ... vn_r30711/

regards

fast report!!

Finally, I have my G300NH v1 with label A2 f0B working!

It never boots with all previous versions successfully.
But now I am able to see the login screen!

Thanks for your hard work

I just noticed that the system time seems not to change at all.

I've try the built-in server and custom server. I also changed the update interval and reboot the router. It still did not work?

Edit: It finally changed after reboot twice.

1.5.3 -> 1.5.4 upgraded without problems WR-1043ND v1.8. Thanks.

1.4.7 working fine on my WRT54GL. One thing I have been doing is removing the b43-legacy module from /etc/modules.d/ since it is loaded but not used. This seems to help free up some precious memory.

Just did an upgrade from 1.4.6 to 1.4.7 and a restore of the config, all good no problems on a TP-Link 1043nd.

tested on my net gear wndr3700V2 works perfectly love QOS it's awesome, best firmware I've ever used.

Upgraded then reconfigured from scratch