Gargoyle Forum

pbix wrote:Check your modem logs. Most likely a problem with your line or ISP. There have been no recent changes in Gargoyle related to PPPoE.

My modem is OK in 100%. Other fw like stock or dd-wrt is fine and stable. I reverted back to dd-wrt build 15962 and everything is perfect with connection now.

Do you use yr modem in half-bridge mode?
Get access to yr router by putty then read yr logread. Can you see repeatedly yr ISP's ip connections here from?
Whats yr routers GW versus IP?

behappy wrote:Do you use yr modem in half-bridge mode?
Get access to yr router by putty then read yr logread. Can you see repeatedly yr ISP's ip connections here from?
Whats yr routers GW versus IP?

I have d-link 360r adsl router, I don't know anything about supported bridge modes of this router.
GW:145.236.238.95
IP: 84.2.71.177

Couple of issues:

Atheros gear doesn't use WDS in the same way as broadcom does; you still need to enable a virtual AP when using WDS in order for other devices to be able to connect to the AP. Essentially needs to work pretty much the same way as repeater bridge mode, but using "option 'wds' '1'"...(this works fine, tested using modified wireless configs)

Refresh time when rebooting isn't long enough...needs about another 20 seconds added to it so that the router will have restarted in time to serve the webpage...

Tested out with 2x Netgear WNDR3700

HI, How do I set PPPoA on gargoyle? I need it for my ISP.

Gargoyle does not support PPPoA.

Only PPPoE is available.

New to this forum and the firmware.

When I try to check out B/W Distribution it allows me to view by minutes, quarter hours, hours, days, and months. All seem to work fine except for days. When I click on days, the distribution interval drop down doesn't change and allow me to select a day. I know this feature worked when I first installed the firmware, and still occasionally does work. Also, sometimes the B/W Distribution page opens, but the pie charts and the B/W Distribution table doesn't load.

The issue occurs in both Safari and Firefox.

I'm running a wrt54g-tm

neyoung wrote:When I try to check out B/W Distribution it allows me to view by minutes, quarter hours, hours, days, and months. All seem to work fine except for days. When I click on days, the distribution interval drop down doesn't change and allow me to select a day. I know this feature worked when I first installed the firmware, and still occasionally does work. Also, sometimes the B/W Distribution page opens, but the pie charts and the B/W Distribution table doesn't load.

I've had problems with that screen and the QOS Distribution window as well. I just tried Opera 11 (not the latest, that didn't work) and it works better than any other browser I've tried. If it doesn't show up the first time you click it, click away from it and back to it until it shows up...then it will be there for good (for that session???).

Get it at http://www.oldapps.com

@Eric
looks like this version, and any version since 1.3.9 works on the WRT150n V1.1, but the later version's don't allow wireless to enable. Same applies for wrt350n. Can something in the code have broken this?