Gargoyle Forum

Hi Guys,
New guy here. Thanks for all your hard work!
My router is a Linksys WRT3200ACM. I have installed "gargoyle_1.10.0-mvebu-armada-385-linksys-rango-squashfs-factory.img"
System/Themes are not showing up for me. I have tried "themes*sh", but nothing there except Gargoyle *.
Thanks for any help.

I think you have to add at least one theme, and then maybe refresh the page.

Thanks for the reply. I don't see any themes to add. No themes on plugins page.

Did you refresh the plugins list?

Thanks Lantis. I tried that before with no luck. I rebooted the router, and this time it worked.
Thanks again!

TP-Link TL-WDR4300 v1, running version 1.10.0 with extroot.
Upgraded usinf factory image w/o preserving settings.
Same router was running on 1.9.1 before.

UPDATE: Working stable now. I've tracked down the issue below to be a signal strength problem, separate thread created viewtopic.php?f=11&t=11277

On two ocasions the router stopped responding: I tried browsing the router config page but it timed out. On some occasions it just hanged for a couple of seconds: ssh was frozen for example.

Yes separate thread thanks

Thanks for the hard work. Updated WRT1900AC v2 looking fine.

@Eric

Thanks for the newest update. Could you estimate when the LEDE-based Gargoyle would be released?

Just upgraded my Netgear WNDR3700v2 from 1.5.2

All went smoothly. I didn't try to preserve my settings, but captured them all before upgrading and manually re-entered. I'm not using many of the fancy plugins; namely firewall/port-forwarding, restrictions, QOS-upload.

Appreciate the continued effort on this project!