Factory images gargoyle:
Images are tested, but the risk is yours.
I was presented with a gift = spoiled the wrong firmware device TL-WA801nd-v1
flashed firmware gargoyle_1.6.0-ar71xx-generic-tl-wa801nd-v1-squashfs-factory.bin
the device is working properly, but while looking for the firmware I found USB port pins. They not soldered to the motherboard, bat easy to solder the wires to them and USB connector.
Firmware gargoyle_1.6.0-ar71xx-generic-tl-wa801nd-v1-squashfs-factory.bin (for Flash 4MiB and Ram 32MiB)
as here http://www.gargoyle-router.com/wiki/doku.php?id=3g
- To be able to use a 3g with Gargoyle
Your Gargoyle router must have a free USB port.
You need 3g/UMTS USB Dongle
An active account with you 3g provider
Routers with at least 8MB of Flash and 32MB of RAM.
But many users change Flash chip at 16 MB: MX25L12805 or S25FL128PIF
I can buy a chip flash memory (MX25L12805 or S25FL128PIF) and programmed by the programming device.
Is it possible to compile the firmware for TL-WA801nd-v1 with support USB and flash 16 MB?