Page 3 of 3
Re: ar71xx builds and TP-Link 4300 stock
Posted: Mon Jul 29, 2013 5:47 am
by pmerrill
No, I've done it with a cut down image via the Gargoyle interface. It did work for 1.5.9, I assume it will work for 1.5.10. You just "upgrade" to the stock firmware but it's not the stock from TP-Link, it's that file but a first section of the file cut off, so it's smaller.
Re: ar71xx builds and TP-Link 4300 stock
Posted: Sat Oct 05, 2013 7:43 pm
by omiez
I Reverted from Openwrt Back to original Firmware with a cutted firmware,this is a must, use a cutted firmware to avoid bricks.
I suppose that Gargoyle the same basis as Openwrt is and this way i can revert back using the same method using the cutted firmware?
Am i right?
Thank you
Re: ar71xx builds and TP-Link 4300 stock
Posted: Sun Oct 06, 2013 4:33 am
by pmerrill
I found this to be so. From memory, check the link here
http://wiki.openwrt.org/toh/tp-link/tl-wdr4300
Re: ar71xx builds and TP-Link 4300 stock
Posted: Sun Oct 06, 2013 5:59 pm
by omiez
Thank you pmerrill
Yes this method works with Openwrt should work on Gargoyle too.
So the difference betwen Gargoyle and Openwrt is basically some improvements and another GUI ?
Right?
Tnx
Re: ar71xx builds and TP-Link 4300 stock
Posted: Fri Oct 11, 2013 10:24 pm
by pmerrill
A good GUI though I think there are some patches here and there, it's not just the overlayed gui, from memory.