Gargoyle Forum

Lantis wrote:It sounds like you need to do a failsafe reset and start again

Ok, just to confirm, that's the following?

type ssh root@192.168.1.1
provide your password
at the Gargoyle prompt type firstboot
wait until the command prompt returns
power cycle the router.

I think you have to do "firstboot -y" these days but yes essentially

Spy,
Is it possible that the packages you posted are out of date? Or a make clean wasn't issued first?
Some packages definitely weren't updated.

--- ignore below this for now ---
Guys using this build, please use the packages repo from here:
http://lantisproject.com/gargoyle_ispyi ... n-12-2017/

Navigate to your particular sub directory and use that.

The easiest way to identify this is to go to the Plugins page on your router and look for the "gargoyle" entry.
For example, the WRT1X00AC(S/M) link for "gargoyle" is Looking at the last two sections of this, "mvebu/default" we now know that the new packages link should be [/size][/color]

all I ever do is

Lantis wrote:I think you have to do "firstboot -y" these days but yes essentially

Ok, I'll give a shot tomorrow and update the forum once complete. It is very strange as I've not run into this one before after 4-5 years with Gargoyle.

Just wanted to let you know that on the WRT3200ACM/Rango, you cannot change or save anything on the connection --> basics tab. The same is true with Lantis-"New Gui" version.

Not sure if this is a help.
https://forum.openwrt.org/viewtopic.php ... 03#p349203


However, this image is working awesome on my WRT1900ACv2. For the moment, I am using the WRT3200ACM(stock) as an Access Point to the WRT1900ACv2.

mojolacerator wrote:Just wanted to let you know that on the WRT3200ACM/Rango, you cannot change or save anything on the connection --> basics tab. The same is true with Lantis-"New Gui" version.

Not sure if this is a help.
https://forum.openwrt.org/viewtopic.php ... 03#p349203


However, this image is working awesome on my WRT1900ACv2. For the moment, I am using the WRT3200ACM(stock) as an Access Point to the WRT1900ACv2.

That's going to be challenging to diagnose without one here.
The driver we have compiled is ok with compat as far as I'm aware (although my understanding of it is not perfect)

If you would like to pm me any errors from logread or a browser console I'll take a look

The "close and apply changes" button on QoS mini window doesn't work for me. The window won't close and the change wasn't saved either. Tested with Archer C7 V2, firefox 50.1, latest stable edge.


Edit: the "close and discard changes" button works as intended, just "close and apply changes" button is broken.

Will check it thanks

Does this include the newer drivers for the WRT1900AC? I have been using Lantis newgui build from November 7.