Gargoyle Forum

Hello,

I have purchased an Auralic Mini to use as a music steamer and am attempting to connect it to a Gargoylr router (TP-Link TL-WR1043N/ND v1 with 1.8,.1). During install I get a message from the Auralic control app that implies the modem/router needs to support USP/multicast SSHP. I have raised it with Auralic but have not had any luck.

I think the problem may be resolved by this: https://wiki.openwrt.org/doc/howto/udp_multicast. But is there a simple/complete explanation for a non network person about what's going on and what needs to be done. Would I be better off raising it at the OpenWRT.org?

As a last (expensive) resort can I simply (ethernet) connect a modem known to work with the Auralic box as a client of the Gargoyle router and take it from there?

Rgds
Tim

I have not seen any discussion relating to your task on this forum over the last 12 months. The link you provided seems worth working thru. I do not see any obvious direct conflicts with Gargoyle but you will need to do all of it via the command line interface. I think it would be worth searching and asking the question at the openwrt forum if no-one shows up here with some direct experience.