Page 1 of 1

setting arp entries manually !

Posted: Sat Jan 11, 2014 3:25 pm
by jackishere
Hey guys,

up until a day ago i was running 1.5.10 and if i remember correctly, i installed net-tools (via opkg) to enable setting arp entries manually using the "arp -s" command.


having upgraded to 1.5.11, i want to do this again, but now i cant seem to find the net-tools package in opkg.

ideas? has it been replaced? is there another way to gain this ability (arp -s) ?

thanks!

Jack

Re: setting arp entries manually !

Posted: Mon Jan 13, 2014 8:42 am
by jackishere
Hello !

no reply yet, hoping someone could point me in the right direction

thanks

Re: setting arp entries manually !

Posted: Wed Jan 15, 2014 8:09 am
by jackishere
What's going on here !

I used to be able to get some sort of reply within a few hours.
is the forum dead now? or is the question just not clear?

come on guys, help me out :)


Jack

Re: setting arp entries manually !

Posted: Wed Jan 15, 2014 1:39 pm
by pbix
Us Gargoyle developers have no connection or knowledge of the package you are referencing.

You should take this up over at OpenWRT.org or with the package maintainer.