WNDR3700V2 - Cannot connect at 300Mbps on 5Ghz channels
Posted: Tue Jan 10, 2012 4:53 pm
Hi!
I am new to Gargoyle and just put gargoyle_1.5.2-ar71xx-wndr3700v2-squashfs-factory.img on my WNDR3700V2 router. I am in Canada but cannot find an NA version for 1.5.2 whereas there are both non-NA and NA versions for WNDR3700V2 in 1.5.0.
Is there a specific NA version that I missed somewhere?
Anyway, the installation went fine but I can only get up to 150Mbps connection with my laptop on the 5GHz wireless although I did specify 40Mhz for the 5GHz channel width (second channel above or below does not seem to make any difference) and max transmit power seems to vary from 17dbm to 30dbm depending on what channel in the 5ghz range I selected.
I did get a full 300Mbps when connecting using 2.4 GHz though.
I was a bit disappointed since I consistently got 300Mbps connection on 5Ghz when using the stock firmware 1.0.0.12.
Please advise on what can be tweaked to get the full 300Mbps rate on 5Ghz.
Thanks.
I am new to Gargoyle and just put gargoyle_1.5.2-ar71xx-wndr3700v2-squashfs-factory.img on my WNDR3700V2 router. I am in Canada but cannot find an NA version for 1.5.2 whereas there are both non-NA and NA versions for WNDR3700V2 in 1.5.0.
Is there a specific NA version that I missed somewhere?
Anyway, the installation went fine but I can only get up to 150Mbps connection with my laptop on the 5GHz wireless although I did specify 40Mhz for the 5GHz channel width (second channel above or below does not seem to make any difference) and max transmit power seems to vary from 17dbm to 30dbm depending on what channel in the 5ghz range I selected.
I did get a full 300Mbps when connecting using 2.4 GHz though.
I was a bit disappointed since I consistently got 300Mbps connection on 5Ghz when using the stock firmware 1.0.0.12.
Please advise on what can be tweaked to get the full 300Mbps rate on 5Ghz.
Thanks.